Can the leaves of Tiger Pilan be transplanted to survive? How to transplant Tiger Pilan to survive?

Tiger Piranha is very common in our daily life. Because it can absorb formaldehyde and purify the air, many families will keep one or two pots of it. So can the leaves of Tiger Piranha survive by cutting? How to make Tiger Piranha survive by cutting? The following editor will explain them one by one, hoping to help you.

Can the leaves of the tiger skin plant survive by transplanting?

The leaves of Tiger Pilan can be cut and survived, but if the Golden Edge Tiger Pilan is cut and propagated, the new shoots may not have golden edges. If you don't mind, you can cut and propagate. I have cut and propagated many pots. You can take a better leaf, cut it off, and then cut it into several sections, so that you can cut and propagate. When cutting, be careful not to reverse the direction, and make sure the head is still facing up.

What should be paid attention to when cutting tiger skin orchid

1. The best temperature for the growth of Tiger Pilan is between 15 and 28 degrees. Spring and autumn are more suitable for cutting Tiger Pilan. The temperature in spring and autumn is relatively mild, without high temperature or severe cold. The suitable season for cutting can increase the success rate.

2. The soil for cuttings emphasizes the use of plain soil, farmland soil plus coarse sand. The soil mixed with the two is loose and breathable, without water accumulation. Plain soil is clean and does not carry germs. It is conducive to wound healing and root growth.

3. The environment is very important when cutting. After cutting, keep it in a shaded location for about 10 days. Then move the pot to diffuse light. The wound of the cutting is basically in the healing stage before about 10 days. Photosynthesis under diffuse light is more conducive to the utilization of nutrients. It can take root as soon as possible.

4. When watering the cuttings of Tiger Piranha, the soil in the pot should be alternately dry and wet. The flower soil should be "dry and wet". Spraying is mainly used to replenish water for the leaves of Tiger Piranha cuttings.

How to propagate tiger skin orchid by cuttings

A leaf can be cut into pieces of about ten centimeters. Prepare sand or sandy soil, or peat soil and vermiculite, etc., and make it loose, breathable and drainable. The cutting depth is about three centimeters, and it does not need to be too deep. Then place it in a ventilated and shaded place. Spray water frequently to keep it moist. Water it as soon as the soil is dry.

It grows roots first, so it sprouts slowly. Generally, it starts to grow roots more than 20 days after cuttings, but sprouting is not certain. As long as the leaves are still full, not rotten or shriveled, it proves that it is alive and continues to grow roots. It will grow sprouts.

Don't pull it out at this time, because it will germinate slowly, but it will definitely germinate. If it's fast, it will sprout in one month, and if it's slow, it may take two or three months. So what we have to do is to wait patiently. It's not as fast as cuttings, but the survival rate of cuttings is relatively high.