How to remove the air in the tempered glass of mobile phone? What to do if there is always a corner of the tempered glass that is not firmly attached?

Adults cannot live without mobile phones almost every day. Now with the popularization of intelligence, the frequency of using mobile phones is getting higher and higher. Because the screen is used a lot, it is very necessary to protect the mobile phone screen. In the process of protecting the mobile phone using film, we will inevitably encounter various small problems and troubles. The following are some relevant tips for you. I hope it will be useful to you!

Contents of this article

1. How to remove the air in the tempered glass of mobile phone

2. What should I do if one corner of the tempered glass film on my phone is not firmly attached?

3. Which is better, tempered glass film or anti-blue light film?

How to remove the air in the tempered glass of mobile phone

Use your fingers or a cotton swab to gently press out any air bubbles.

This is the simplest method. If there is a foreign object inside, there is no way to deal with it unless you replace it with a new one.

After sticking the film, spray a little air freshener on your fingers or nails, and then move along the nails to the edge of the film with bubbles to let it penetrate inside.

For places that cannot be penetrated, use your fingernails to gently scrape the film to the places that cannot be penetrated, then flatten and hold for ten to twenty seconds.

This method is safe, environmentally friendly and harmless to mobile phones. It just uses the rapid volatilization and adsorption principle of air freshener.

If there are bubbles (that is, the air you mentioned) on your mobile phone film, there are the following reasons:

1. There is dust on the screen. Solution: Use a film with adhesive to stick the dust out. See if it is on the screen or the film, stick it out directly and then stick it back on.

2. If there are bubbles next to it, it means that the film is cut or positioned correctly, and the bubbles next to it cannot be dried out. Solution: If it is an original film, you must align it before applying it. If it is a universal LCD film, remember to cut it slightly smaller than the screen.

3. The film is not placed flat and bubbles appear in the middle. It is very simple. Just tear the film until there is air.

What should I do if there is always a corner of the tempered glass film on my mobile phone that is not firmly attached?

step:

1. Use transparent tape to stick to one corner of the tempered glass and slowly pull up the transparent tape.

2. After this corner is flipped up, use another piece of transparent tape to remove the dust on the phone screen.

3. Re-stick this corner.

4. After applying, blow it lightly with a hair dryer to make the film more adherent.

5. If the method is not feasible, it may be a problem with the tempered film itself.

Note: Because the phone has a curved screen, a special film must be used. To avoid warping, be sure to choose a soft film.

Which is better, tempered glass film or anti-blue light film?

Tempered glass film is to prevent the screen from breaking when the phone falls, not to prevent scratches. It has high hardness and low toughness, and can effectively prevent the screen from breaking when the phone falls accidentally. When the phone falls to the ground, it will be subjected to great impact force, and the screen will break if the tension is too large. The toughness of tempered glass film is low, and when the phone transmits tension, the film will bear tension, which greatly reduces the tension on the main screen.

Anti-blue light film is a kind of vision protection film developed for blue light radiation. The blue light mobile phone film adopts blue light blocking technology to absorb and transform blue light, realizing effective blue light blocking. It can effectively block ultraviolet rays, short-wave blue light rays, and soften dazzling light source stimulation, making the feel and hardness of the mobile phone film a perfect combination.