Why do rubber tree leaves fall off when touched? How to remedy the problem of rubber tree losing leaves

The rubber tree is a very ornamental plant in life. Because it can purify the air, it is one of the must-have plants for many flower lovers. So why do the leaves of the rubber tree fall off when touched? How to remedy the problem of the rubber tree falling leaves all the time? The following editor will explain them one by one, hoping to help you.

Why do rubber tree leaves fall off when touched?

1. Rubber trees like high temperature and high humidity environment. Too low temperature will cause the rubber tree to drop its leaves, especially in winter. Generally, when the temperature is below ten degrees Celsius, the rubber tree will start to drop its leaves.

2. Rubber trees are sun-loving plants and need to be placed in a sunny place with good light. It is best to be exposed to sunlight all day in winter. If placed in a dark place, it will cause the leaves to fall off.

3. Too much or too little watering can also cause the rubber tree to drop leaves. If you water too little, the moisture in the potting soil is not enough to supply the transpiration of the leaves, so the leaves will naturally fall off. On the contrary, if you water too much, especially in winter when the temperature is low, the moisture in the soil cannot be drained away, which will cause root rot and leaf drop is inevitable.

4. If the rubber tree is fertilized too much, it will rot and the leaves will fall naturally. The concentration should be lower and the principle of frequent and thin fertilization should be followed. On the contrary, too little or no fertilization will also cause the leaves to fall.

5. Rubber trees should not be placed indoors for a long time. Take them outside to breathe fresh air after a while. Poor indoor ventilation will lead to excessive carbon dioxide concentration, causing yellow leaves to fall.

How to fix a rubber tree that keeps losing leaves

1. Soil

The best soil is well-rotted soil (to put it simply, it is the soil from rotten leaves under corn piles in the countryside or near the woods, etc.), add one-sixth of sand or a small amount of perlite to the soil.

2. Water

The most taboo in watering flowers is to water less frequently and water more often. It is best to water the flowers when they are dry and wet them thoroughly at one time. I use my fingers to poke the soil, which feels the best. Watering too frequently will cause water to accumulate in the flower soil; watering too lazily will cause the flower soil to dry and crack. Both will cause the flowers to become abnormal, or even drop leaves and die. It is best to water them for a few days. If conditions permit, it is best to use boiled fermented soybean water (soybean water plus fermented water 1:3) to water the flowers.

3. Light

We all know the role of light, so it goes without saying. Rubber trees are plants that like light. So it is best to place the rubber tree on the sunny side. Use a spray bottle to spray it appropriately to create a humid climate. My rubber tree was originally placed in the living room, where it could hardly see any light. Later, I moved it to the sunny side, and it grew well little by little.

4. Wind

Flowers need ventilation. So flower lovers should open the doors and windows appropriately, just like we breathe fresh air. Rubber trees like warm, humid environments. Leaf shedding is nothing more than insufficient light and poor ventilation; excessive water causes root rot; insufficient water causes the soil to dry out and crack, and the water cannot keep up with the root absorption. If you want to make the rubber tree flourish, start with these points.

How to solve the problem of not being able to grow a rubber tree well

Rubber trees like fertile and loose sandy soil and water. Water once a day in summer and once every 4 to 5 days in spring and autumn. Spray water on the leaves frequently to keep the leaves clean. Rubber trees like fertilizer. When repotting or changing pots, a layer of decomposed fertilizer should be placed at the bottom of the pot as base fertilizer (it should not be in direct contact with the roots and should be covered with a layer of culture soil). Apply decomposed liquid fertilizer every 10 days on a daily basis, return water the next morning, and spray the leaves with a spray bottle. It should be overwintered indoors in the winter, placed in a sunny place, and no fertilizer or water should be applied.